Epson PhotoPC 800, Service Manual

Page: 77 / 110

EPSON PhotoPC 800 Revision A
Adjustment Overview 77
Figure 5-1. Setting-Up before adjustment
1. Turn off both Camera and PC.
2. Locate the port cover on the side of the camera. Press on the arrows and
slide the cover down to open it.
3. Line up the arrow on the cable connector with the notch on the camera’s
serial port. Insert the connector.
4. Locate a serial port on the back of your computer. You may have two serial
ports labeled COM1 and COM2, or the ports may be labeled with icons. If
you have two serial port available, use port1 to connect your camera.
5. Line up the serial connector on the cable with one of serial ports on your
computer, and insert the connector.
6. Turn on the camera and your computer system.
7. Insert the calibration software into the disc drive.
8. Double-click “DSCCalDi.EXE” in the disc and activate the program.
Figure 5-2. Initial Screen of Adjustment Program
AC adapter
Serial Cable
To COM1 or COM2
serial port
JEP-6
C A U T I O N
„
Error message “Camera is not connected” will be
displayed, when you try to activate the program without
turning the power of the camera On.
„
When using the Color Viewer, turn on the switch and wait
for 30 minutes for aging to take place before using Color
Pure.