Epson M200, Service Manual

Page: 78 / 85

M200 / M205 / M100 / M105 Series Revision A
Confidential
Maintenance Lubrication Points and Instructions 78
Figure 4-12. Lubrication of the Main Frame Assy
<Part supply as ASP>
Supplied as the Printer
Mechanism
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
1. Contact point (x1) on
the upper side of the
Main Frame Assy with
the CR Unit
2. Contact points (x4) on
the lower side of the
Main Frame Assy with
the CR Unit
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Main Frame Assy
Main Frame Assy
Frame Base
CR Unit
Application Point
Figure 4-13. Lubrication of the Hopper Figure 4-14. Lubrication of the CR Driven Pulley Assy
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Contact point on the
Hopper with the Frame
Base
<Type>
G-74
<Application Amount>
Appropriate amount
<Remarks>
†
Apply with flux
dispenser.
†
Stir G-74 before use.
Hopper
Application Point
<Part supply as ASP>
None
<Lubrication status when
supplied as ASP>
---
<Lubrication Point>
1. On the bearings (x2) of the
CR Driven Pulley on the
CR Driven Pulley Holder
2. Contact points (x6) on
the groove of the CR
Driven Pulley Holder
with the Main Frame
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
†
Apply with injector.
†
Check the lubrication
condition and apply
grease if necessary.
CR Driven Pulley Holder
2. Application Point
1. Application Point
Figure 4-15. Lubrication of the LD Roller Assy
<Part supply as ASP>
Supplied as the LD Roller
Shaft
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Cam of the contact point
with the Hopper/Paper
Back Lever (x2)
<Type>
G-71
<Application Amount>
φ
1 mm x Appropriate
amount
<Remarks>
†
Apply with injector.
†
Apply before attaching
the LD Roller Assy.
†
After applying to the
specified position,
rotate the EJ Roller
Gear to spread the
grease.
LD Roller Assy
EJ Roller Gear
Application Point
Figure 4-16. Lubrication of the EJ Roller Figure 4-17. Lubrication of the EJ Roller Gear
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Contact point (x1 on the
shaft) on the EJ Roller with
the Frame Base
<Type>
G-71
<Application Amount>
0.06 g
<Remarks>
†
Apply with injector.
†
Lubricate before
attaching the part.
Frame Base
EJ Roller
Application Point
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Shaft on the EJ Roller
Gear
<Type>
G-71
<Application Amount>
φ
1 mm x 1 circle
<Remarks>
†
Using injector, apply
grease along the tier on
the shaft.
†
Lubricate before
attaching the part.
EJ Roller Gear
Application Point