FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions. The user may find the following booklet prepared by the Federal
Communications Commission helpful: “Television Interference Handbook.” This booklet is
available from the U.S. Government Printing Office, Washington DC
20402.
Stock No.
004-000-
00450-7.
The
connection of
a
non-shielded
equipment interface cable to this equipment will invalidate the
FCC Certification of this device and may cause interference levels that exceed the limits established
by the
FCC for
this equipment. If this equipment has more than one interface connector, do not
leave cable connected to unused interfaces.
Seiko Epson Corporation shall not be liable against any damages or problems arising from the use
of any options or any consumable products other than those designated as Original Epson Products
or Epson Approved Products by Seiko Epson Corporation.
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or
transmitted, in any form or by any means, mechanical, photocopying, recording, or otherwise,
without the prior written permission of Epson America, Inc. No patent liability is assumed with
respect to the use of the information contained herein. While every precaution has been taken in
the preparation of this book, Epson America, Inc. assumes no responsibility for errors or
omissions. Neither is any liability assumed for damages resulting from the use of the information
and contained herein.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’ émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de Classe B prescrites dans le règlement sur le brouillage
radioélectriques édicté par le Ministère des Communications du Canada.
Epson and Epson ESC/P are registered trademarks of Seiko Epson Corporation.
IBM is a registered trademark of International Business Machines Corporation.
SmartPark is a trademark of Epson America, Inc.
Copyright © 1989 by Epson America, Inc.
Torrance, California
ii
Summary of Contents for LQ-1010
