C O N F I D E N T I A L
Paper roll
Bar code commands GS k
Ver. 4.0
p. 1263
[Notes for
➀
and
➁
]
■
When standard mode is selected, this command is enabled only when no
data exists in the print buffer. If data exists in the print buffer, the printer processes the
data following
m
as normal data.
■
If
d
is out of the specified range, this command is canceled and the printer processes the
following data as normal data. In this case, when standard mode is selected, the printer
only feeds paper and when page mode is selected, the printing position does not change.
This applies to all bar code systems.
■
When standard mode is selected, if the bar code width exceeds the printing area, the
printer only feeds paper.
■
When page mode is selected, if the bar code width exceeds the printing area, the printer
does not print the bar code but moves the printing position to [printing area + 1].
■
This command feeds as much paper as is required to print the bar code, regardless of the
line spacing specified by
ESC 2
or
ESC 3
.
■
When page mode is selected, this command develops the bar code data in the print buffer
but the printer does not print the bar code data.
■
The bar code is not affected by print mode (emphasized, double-strike, underline,
character size, white/black reverse printing, or 90° clockwise-rotated), except for upside-
down printing mode.
■
The values of
m
from 0 to 6 and from 65 to 71 select the same bar code system, respectively.
The printing results are the same.
