Epson ActionNote 866C, User Manual

Page: 53 / 139

N o t e
If you are using an ATA hard disk or ATA flash card, make
sure your CONFIG.SYS file contains this command:
DEVICEHIGH=C:\CARDSOFT\ATADRV.EXE
If you are using an SRAM card, make sure the CONFIG.SYS
file contains this command:
DEVICEHIGH=C:\CARDSOFT\MTSRAM.EXE
Both of these drivers are loaded in your computer’s
CONFIG.SYS file at the factory.
The following table describes the removable storage card
utilities.
ATA utility commands
Command
ATAINIT*
ATADRV
MTDDRV
Function
Partitions the ATA card and identifies its physical
parameters: then you can use MS-DOS FORMAT to format
the drive.
Assigns the next available drive letter to the ATA drive.
When you start your system, you see a message identifying
the drive letter assigned to the drives in your PCMCIA slots.
Displays the drive letter for SRAM and ATA cards. Since these
cards share drive letters, it is important to know where these
cards are installed.
* This command works only with ATA cards that are supported by the
ATADRV driver.
2-18 Using Your Computer