If you want to save the settings you entered, highlight
** EXIT AND SAVE
**
and press
Enter
at a Setup
summary screen. The Setup program stores the new settings and
resets the computer using the new configuration. If you have set
a password, you need to enter it at the key prompt. (See “Using
a Power-on Password” in Chapter 3 for instructions.) The
Operation Menu appears. Press 0 and
Enter to
exit the
Operation Menu.
After you save the settings you entered, remove the Reference
diskette from your diskette drive and turn off your system. Then
follow the instructions in your MS-DOS Installation Guide to
install MS-DOS. (If you are using a different operating system,
follow the installation instructions in that manual.)
If the computer displays an error message while it is starting up,
run the Setup program again and check the setting the error
message indicates. If the computer still displays an error message
after you check your Setup program settings, see Appendix E or
ask your dealer for assistance.
After you have installed MS-DOS on your hard disk, you should
always boot the computer from the hard disk to use MS-DOS. If
you boot from your Reference diskette to run Setup or System
diagnostics, remove the diskette from drive A and reset your
computer when you are finished running the program. This
ensures that your system performs all the commands in your
CONFIG.SYS and AUTOEXEC.BAT files each time you use
MS-DOS.
Note
Be sure to make a backup copy of your Reference diskette
after you run the Setup program and install MS-DOS. See
your MS-DOS Reference Manual for instructions on how to
copy diskettes.
2-32
Running the Setup
Program
