Stand 02.01.09, GB 33, Geared head drill Page 22 of 52
3.4
Positioning and assembly
3.4.1 Claims to installation location
The machine may not be in an explosive area. The machine is therefore
not construed. The acceptable environmental conditions have to be
followed at the installation location. Organise the installation location
according to the safety regulations for the use of this machine. See that
the installation location is not limited for the use, attendance and
maintenance.
Guarantee a boundless and free amenability of the mains plug and all
operation unit of the machine.
3.4.2 Load rope stops
The machine only may lift at the adequate areas and with adequate tool
and the load rope Stop devices. Observe the balance point of the
machine. Observe that no add
– on – part or the lacquer get damaged.
3.4.3 Assembly
Observe that the bottom/ ceiling are stable enough at the installation
location. If the rigidity is deficient, it can come to oscillations between
machine and bottom. This can lead to failures at adjoining units and
machines.
3.4.4 Anchor
– free assembly
Attention!
An anchor
– free positioning is not allowed because of safety causes
and therefore it is forbidden!
3.4.5 Anchored assembly
Observe that the machine is anchored safe and correctly. Assure that you respect
the internal safety regulations.
Attract the anchor screws across balanced and not too feast, to avoid a break of
the stand. Adjust the machine perpendicular.
3.4.6 Positioning plan
See during positioning of the machine that the working place is designed
ergonomic.
Observe during position the machine the accident prevention regulations for your
business. The use, attendance and maintenance may not be limited. Bethink: A
cramped work place retrieves accident risks.
