EPOX M762A Series, Installation Manual

Page: 51 / 68

Award BIOS Setup
3.7 Integrated Peripherals
CMOS Setup Utility – Copyright © 1984 – 2001 Award Software
Integrated Peripherals
IDE Read/Write Prefetch
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
Init Display First
IDE HDD Block Mode
KBC Input Clock
Power On Function
X KB Power On Password
X Hot Key Power On
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
X RxD, TxD Active
X IR Transmission Delay
X UR2 Duplex Mode
X Use IR Pins
Onboard Parallel Port
Parallel Port Mode
X EPP Mode Select
X ECP Mode Use DMA
Enabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Enabled
Enabled
PCI Slot
Disabled
8MHz
Button Only
Enter
Ctrl-F1
Enabled
3F8/IRQ4
2F8/IRQ3
Normal
Hi, Lo
Enabled
Half
IR-Rx2Tx2
378/IRQ7
SPP
EPP1.7
3
Item Help
____________________________
Menu Level 
If your IDE hard drive supports
block mode select Enabled for
automatic detection of the optimal
number of block read/write per
sector the drive can support

Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General
Help
F5: Previous Values F6: Fail-safe defaults F7: Optimized Defaults
IDE Primary/Secondary Master/Slave PIO:
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode
(0-4) for each of the four IDE devices that the onboard IDE interface
supports. Modes 0 through 4 provide successively increased performance.
In Auto mode, the system automatically determines the best mode for each
device.
The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3 and Mode 4.
44