EPOX M762A Series, Installation Manual

Page: 18 / 68

Installations
2.1.3 Setting Jumpers and DIP Switches
There are jumpers and DIP-switches on the system board of the M762A
series. You can set the jumpers to make the necessary operations.
Figure 6: Jumper Connector
For any three-pin jumpers (figure 6), the jumper setting is 1-2 when the
jumper connects pins 1 and 2. The setting is 2-3 when pins 2 and 3 are
connected and so on. You see a number “ 1 “ and a “ 3 “ printed on the
circuit board to identify these pins. And also, there is a second way of
indication – one of the lines surrounding jumpers is thick, which indicates
pin NO.1.
To move a jumper from one position to another, use needle-nose pliers or
tweezers to pull the pin cap off the pins and move it to the desired position.
11