3-16 CHAPTER 3
Onboard UART 2 Mode:The default value is standard. This field allows the User to
select the COM2 port that can support a serial Infrared Interface.
Standard: Support a Serial Infrared Interface IrDA.
HPSIR: Support a HP Serial Infrared Interface format.
ASKIR: Support a Sharp Serial Infrared Interface format.
Onboard Parallel port: This field allows the user to sellect the LPT port. The
default value is 378H/IRQ7.
378H
: Enable Onboard LPT port and address is 378H and IRQ7
278H
: Enable Onboard LPT port and address is 278H and IRQ5.
3BCH
: Enable Onboard LPT port and address is 3BCH and IRQ7.
Disabled
: Disable Onboard LPT port.
Parallel port Mode: This field allows the user to sellect the parallel port mode. The
default value is ECP+EPP.
Normal
: Standard mode. IBM PC/AT Compatible bidirectional parallel port.
EPP
: Enhanced Parallel Port mode.
ECP
: Extended Capability Port mode.
EPP+ECP
: ECP Mode & EPP Mode.
ECP Mode USE DMA: This field allows the user to sellect DMA1 or DMA3 for
the ECP mode. The default value is DMA3.
DMA1
: The filed selects the rounting of DMA1 for the ECP mode.
DMA3
: The filed selects the rounting of DMA3 for the ECP mode.
NOTE
: Parallel Port address is 378H/3BCH that selects the rounting of IRQ7 for LPT1.
Parallel Port address is 278H that selects the rounting of IRQ5 for LPT1.
3-7
LOAD SETUP DEFAULTS
The "LOAD SETUP DEFAULTS" function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.
