Epiroc ER 100 L, Safety And Operating Instructions Manual

Page: 68 / 96

Safety and operating instructions
68 © Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
10 Storage
10.1 Drum cutter
10.1.1 Short storage
Proceed as follows in the case of storage for less than
three month:
n
Remove the drum cutter from the carrier (see chapter
Removing the hydraulic attachment from the car-
rier ).
n
Always store the drum cutter:
- secured on the assembly stand
- dry, free of dust and free of contamination
- free of mechanical shocks
- protected from mechanical damage
n
Check the general condition of all parts and the pack-
aging regularly.
10.1.2 Long storage
For storage of more than 3 months extra procedures
must be performed in addition to short storage.
In order to guarantee protection of the internal parts of
the hydraulic motor, implement the following protective
measures with respect to the hydraulic motor:
The measures listed in the following table depend on the
duration of storage and the ambient climate of the stor-
age site.
Duration of
storage
Climate range
Moderate Tropical Coastal
3 months A B C
6 months B C D
12 months C C D
24 months C D D
Explanation to the measures specified in the table per-
taining to storage:
A No special maintenance measures necessary.
Apply plugs and closures.
B Fill hydraulic motor with hydraulic oil.
C Rinse hydraulic motor with preservation agent.
D Fill hydraulic motor with preservation agent.
10.2 Cutter drum
n
Remove the round attack picks, if the cutter drum are
stored for an extended period, (see chapter Replace
round attack picks ).
n
Preserve the cutter drum with oil.
10.3 Round attack picks
If the drum cutter is stored for an extended period, de-
tach the round attack picks because these can corrode
with the cutting material and bond together with the pick
boxes.
n
Remove the round attack picks (see chapter Replace
round attack picks ).
n
Preserve the round attack picks with oil.
n
Store the round attack picks protected against con-
tamination and mechanical damage.
NOTICE Damage due to increased wear
Dust and dirt adhere to oily surfaces and lead to in-
creased wear.
u
Clean oiled parts before reassembly.