Epiroc ER 100 L, Safety And Operating Instructions Manual

Page: 52 / 96

Safety and operating instructions
52 © Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
7.10.2 Replace round attack pick with
retaining sleeve
The following special equipment is required to replace
the round attack picks:
• Puller (E) for pick with retaining sleeve
The special equipment is included in the scope of deliv-
ery.
The round attack pick has a notch (see arrow).
1. Slide the puller (E) into the notch of the round attack
pick with the impact surface (F) directed to the cutter
drum.
E
F
2. Grip the puller (E) firmly in the hand.
3. Give the impact surface (F) of the puller (E) a forceful
blow with a hammer.
The round attack pick will loosen from the pick box.
4. Pull round attack pick out of the pick box.
5. Clean the pick box.
6. Place a new round attack pick (G) in the notch of the
puller. The tip of the pick must point in the direction of
the impact surface (F).
G
F
7. Place the new round attack pick in the puller and
place in the opening of the pick box (H).
H
F
8. Give the impact surface (F) of the puller a forceful
blow with a hammer.
The round attack pick is anchored in the pick box by
the retaining sleeve on the shaft.