EPAK DSi13Ku Pro, Installation And User Manual

Page: 24 / 32

5.3.3 Configuration -> Antenna
Here you can see a list of beams for every configured satellite. To select a new beam, click on one of the
beams shown on this page and the antenna will automatically repoint to this new beam.
5.3.4 Configuration -> Satellite
The user can view and configure new satellites in this section.
Each widget on the page represents a satellite and its beams.
The user can edit or delete each entry of this section. To confirm
the changes, please click on the check “
✔
” button and to roll-
back click on cancel “ ✖ ” button.
You can also add new Satellites in this section.
Click on the
button on your screen, then enter the satellite name, the
position and tilt if any. To save your entry, click on the check
“
✔ ” button and to undo your changes click on cancel “ ✖ ”
button.
*Note - If the satellite is in the West orbit, you must enter a
negative number in the Position field. eg. 22West will be -22.
To add new beams for a satellite, click on “Beam+” button and
enter the beam ID, receive polarity, receive RF frequency and
symbol rate in ksym/s. The beam ID can be any number
between 1 to 9999. To save your entry, click on the check “
✔ ”
button and to undo your changes click on “ ✖ ” button.
5.3.5 Configuration -> Update
This section is used for updating the antenna firmware or
updating the ACU Software version. To use this section, please
contact the EPAK IT team.
5.4 Account Details
Doc ID 0304 03.07.20
Page 24/32