F
Display
Displays the current status of the ACU and antenna.
G Input Buttons
The input keys lets you navigate the menu and access quick settings.
H Sim Slots
The user can insert standard SIM cards in SIM1 or SIM2
Back-Panel Schematic:
A: IDB1 Connector
G: NMEA Connector
M: Modem RX
B: IDB2 Connector
H: NMEA Protocol Select
N: Modem TX
C: Serial Connector RS232
I: GPIO Connector (opt.)
O: Antenna TX
D: WAN Connector
J: LTE Antenna connector
P: Fan Outlet
E: LAN 2 Connector
K: USB Port
Q: Slave Mains Power Connector
F: Open BMIP Connector
L: Antenna RX
R: Mains Power Input and Switch
A
+
B
IDB Connector (RJ45)
Use these ports to connect several EPAK devices together (e.g.
DivKit, second ACU, heating controller).
Use only if you are instructed to do so by a technician.
C Serial Connector RS232 (RJ45)
Connect this port to a RS232 device which should be controlled by
the ACU.
Use this port only if you are instructed to do so by a technician.
D WAN Connector (RJ45)
Connect this port to the WAN port of your modem.
E LAN 2 Connector (RJ45)
Connect this port to your local network, a network switch or a PC.
F
Open BMIP Connector (RJ45)
Use this port to connect a modem which supports Open BMIP.
Use only if you are instructed to do so by a technician.
G NMEA Connector (two pole)
Use this port to connect (if available) the ACU to your vessels
compass. Observe correct polarity.
H NMEA Protocol Select Switch
Set this switch according to the used NMEA protocol on your vessel
(RS232 or RS422/RS485).
Change only if you are instructed to do so by a technician.
I
GPIO Connector
Optional connector to extend the ACUs connectivity by two general
purpose inputs or outputs.
J
LTE Connector
Connect the LTE antenna to this port
K USB Port
Use this port to communicate serially with the ACU
L
Antenna RX (N)
1
Connect the RX cable from the antenna to this port.
M Modem RX (TNC)
Connect to the RX port of your modem.
N Modem TX (TNC)
Connect to the TX port of your modem.
O Antenna TX (N)³
Connect the TX cable from the antenna to this port.
P Fan Outlet
The ACU is a high power device, make sure that the fan outlet is
never obstructed.
Doc ID 0304 03.07.20
Page 17/32
Figure 5.2: ACU rear view
Summary of Contents for DSi13Ku Pro
Page 29: ...Drilling Pattern DSi6 Doc ID 0304 03 07 20 Page 29 32 Figure 8 1 Drilling Pattern 60cm VSAT...
Page 30: ...Drilling Pattern DSi9 Doc ID 0304 03 07 20 Page 30 32 Figure 8 2 Drilling Pattern 90cm VSAT...
Page 31: ...Drilling Pattern DSi13 Doc ID 0304 03 07 20 Page 31 32 Figure 8 3 Drilling Pattern 130cm VSAT...
