EPAK Basic Line Series, Manual

Page: 5 / 34

1.2. Safety recommendations
1. Please consider the maximum allowable power voltage for the antenna unit. The DC voltage must be
between 12 and 36 volts and the overload protection should be rated at min. 5 amp. and max. 7.5
amp..
2. The mounting distance from the antenna unit to other radiation sources, e.g. radar equipment or other
transmitting antennas, should be at min. 2.5 m (8 ft).
3. If the satellite antenna is not installed above the radar antenna, simultaneous operation of both
systems may damage the satellite antenna.
4. Do not use the control unit outdoors!
5. During a thunderstorm, we recommend to disconnect all connection cables.
6. If the negative side of the antenna unit’s supply voltage has no connection to the ship’s ground (earth),
then the antenna unit’s ground point should be connected directly to the ship’s ground (earth).
7. After the installation is completed all other electronic systems, i.e. GPS, Radar, VHF, FM, AM etc.,
should be tested for full functionality while the antenna is turned on.
8. Do not test or turn on the antenna before the radome is fitted correctly. The electronics can be
damaged by the reflected sun.
9. Do not touch the rotary joint.
10. Do not open the sealed electronic box, as this will void the warranty.
English Page 5 / 34