EP Equipment IMOW ICE251, Operation Manual

Page: 38 / 95

31
37. Nameplate
There is operate method and warning label on the truck. Please operate the truck
obey the rules on the label and this manual.
Often inspect the nameplate, when damaged or lost please replace it.
38. Noise
The noise of truck is less than 75dBA, test method is use a decibel tester to record the
voice 7 meters far away from truck. The decibel near operator’s ear is less than
95dBA.
39.Vibration and acceleration
When unlading, operator’s vibration of acceleration is about 0.74m/s2; when laden, is
about 0.18m/s2; so when operate on a uneven ground, it may cause more vibration
for truck and operator
3.2 Operate and run the truck
3.2.1 Preparing
Before the truck can be commissioned, operated or a load unit lifted, the driver must
ensure that there is nobody within the hazardous area.
Checks and operations to be
performed before starting daily
work
– Visually inspect the entire truck (in
particular wheels and fork) for obvious
damage.
– Visually inspect the battery and cable
connections.
3.2.2 Switching on the truck
⑴
Put the travel combination switch to center position.
⑵
Plug into the connector if necessary;
⑶
Turn on key switch
Close the wheel lever with left hand and turn on the key switch with right hand.
⑷
Tilt back the mast
Control the lifting lever to set the bottom of the fork 150-200mm above the ground.
Control the tilting lever to fully tilt back the upright.
⑸
Control shift lever
Warning!
Before operating the truck, check all
controls and warning devices for
proper operation. If any damage of
fault is found, don’t operate truck until
corrected.