EP Equipment EPT20-15ET, Service Manual

Page: 58 / 128

47
REV. 09/2016
OPERATING SYSTEM
6
6.1 Control Lever
Removal
-
-
-
Remove four screws (1) , lift up cap assem-
bly (2);
Disconnect control lever wiring harness from
wiring harness;
Unscrew two screws (4), remove the control
lever (3).
Control lever is mounted on control arm (5, Fig-
ure 30301).
-
Install according to the reverse order of rem-
oval.
When removing or installing, please pay attent-
ion to protect the cables from being damaged.
Installation
CAUTION
Control lever is used to control the travel, lifting,
lowering, horn and emergency reverse of the
vehicle.
6.2 Button Switch
Push button switch is the switch that makes
the dynamic and static contacts ON or OFF to
achieve the switching of circuits through push-
button drive mechanism. In the electrical control
circuits of this truck, the push button switch is
used for manual emitting of control signals to
control the vehicle lifting, lowering, horn and
emergency reverse.
By function:
- Lifting Button Switch
- Lowering Button Switch
- Horn Button Switch
- Emergency Reverse Switch
6.2.1 Removal and Installation
Lifting/Lowering/Horn Switch
(See Figure 30302)
-
-
-
Remove pin (6&18) securing switches (16) ;
Unscrew three screws (11), remove the wire
clamps (12) and remove the lifting-lowering-
horn switch wiring harness (15).
Install according to the reverse order of rem-
oval.
Lifting Switch
Lowering Switch
Horn Switch
Lifting-Lowering Button
Lifting-Lowering Button
Horn Button