Relay Box for Infrared Cabins - Installation Instructions
47
Installing multiple cabins
3
Pull the S bus line from the relay box through the ferrite ring twice.
4
Slide the ferrite ring onto the bridge on the mounting plate.
5
Connect control lines to socket 1/2 using the RJ10 plugs.
EmoTouch 3 circuit board – jacks
Plug for multi-cabin connection, see Installing multiple cabins,
6
NOTICE You must follow the correct connection sequence. If the cabin
address does not match the connection, the cabin is not detected.
Press and hold the programming button on the circuit board of the relay
box for approx. 4 seconds until the red LED starts flashing.
Programming mode is active. The green LED light goes off.
RJ10
RJ14
7/8
5/6
3/4
1/2