4
For these steps you will need the PRV4X6 kit & the Etatron eOne MF Pump
Take the
PRV4X6
kit out of the box. The outer holes
on the bracket are used for mounting the PRV4X6
to a surface. Those need to be drilled out to
accommodate ¼” screws/bolts.
Take your pump from its box and mount it on the
wall using the bracket included with the pump. Grab
the Opaque Rigid Polyethylene Discharge Tube
(
ORPDT
) included with the pump, and cut it in half
(if cut too short the tension may cause leaks).
Connect each one of the tube’s halves to the
Adapters
on the
PRV
(see Steps 14 - 15).
To attach the tubes to the
PRV
, insert the tube
through the outside opening of
PRV Nut
. Insert the
Locking Collar
making sure the
Collar’s
crown
points away from the
Nut
. Now, insert the
Nozzle
in the tube’s opening. Push the
Collar
and
Nozzle
together as close as possible. Repeat for the other
tube half.
Now attach the ORPDT to the
Adapters
on the
PRV
using the
Nuts.
12
13
14
15
Assembly & Connection of the PRV
to the Etatron Pump
(
ORPDT
)
Opaque Rigid
Polyethylene
Discharge Tube
flow
LOCKING
COLLAR
TUBE
NUT
NOZZLE
TUBE
NUT
COLLAR &
NOZZLE
