www.enware.com.au
Call 1300 369 27
5
FRONT
PANEL
FIXING
SCREWS
installation
DFSA121-PBBF water chiller is ready for final assembly on
site.
Remove water chiller and bottle filler from the packaging.
Remove the front panel of the chiller unit by unscrewing
the two fixing screws. Pull panel forward and slide down to
remove the front panel. SEE IMAGE 1
IMPORTANT - Ensure chiller unit is disconnected from
power supply before accessing the inside of the chiller
unit.
INSTALLING BOTTLE FILLER
1. Fit bottle filler to the basin top of the water chiller,
ensuring the location pin fits into the pre-drilled hole.
Fit spacer washer and backnut from underneath, and
tighten the backnut with a spanner to secure the bottle
filler assembly. SEE IMAGE 2
2. Screw the tube adaptor to the 1/2” bottle filler thread,
ensuring that the rubber seal is in place in the adaptor -
tighten firmly, but do not overtighten. SEE IMAGE 2
3. Push the 1/4” tube firmly into the adaptor socket until
it bottoms out - pull back gently to check that the tube
has locked. SEE IMAGE 3
IMAGE 1
IMAGE 2
Push tube in to connect.
Pull back gently on the tube
to check it is locked.
To disconnect, ensure the system
is depressurized, push the collet
square against the fitting.
With the collet held in this position
the tube can be removed.
IMAGE 3
