ENVO SNOWBIKE KIT MANUAL
|
VERSION 1.2
41
6.6.G E N E R A L P R O J E CT S E T T I N G
6.6.1. M A X I M U M T R I P S PE E D
Under power off status, hold button (SW), until the meter is turned on. Within 5 seconds
after boot-up, hold button (UP) and button (DOWN) simultaneously for about 2 seconds,
the first is to enter the maximum riding speed setting interface, then the speed display column
flashes. Hold button (UP) shortly or button (DOWN) in order to set the maximum riding
speed value. The default maximum riding speed value was 25km/h. When the speed of the electric
vehicle exceeds the set value, the motor will be stopped driving.
Under the setting maximum riding speed interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to Display 1, and the original set
values will be saved.
After finishing the maximum riding speed setting, hold button (SW) shortly to save the current
set values and enter into the next setting.
6.6.2 . M E T R I C A N D I M PE R I A L U N IT S
Enter into the metric/imperial units setting interface, and then the speed and mileage unit flash.
Hold button (UP) or button (DOWN) shortly to make sync selection of three metric/
imperial units as speed, mileage, and the environment temperature.
U N IT S D E FI N ITI O N TA B L E O F M E T R I C/I M PE R I A L U N IT S
D I S PL AY
M E T R I C
I M PE R I A L
Riding speed
km/h
mph
Total distance
km
mi
Environment temperature
°C
°F
Under the metric/imperial units setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to Display 1, and the original set
units will be saved.
After finishing the metric/imperial units setting, hold button shortly (SW) to save the current
set values, and then speed and mileage units stop flashing. Hold button (SW) shortly again,
and the meter will enter into the maximum riding speed interface again, or hold button (SW)
long for about 2 seconds to exit the general project setting environment and return to Display 1.
