15
Maintenance And Service
f
ace
R
emovaL
:
Figure 17. Top latches for glass door
Figure 18. Bottom Alignment Slots for glass door
Door Latch Mechanism
Door Tool Hole
Alignment Slot
(both corners)
In order to install the log set, and
for regular cleaning, the glass door
must be removed. The face must
first be removed, as outlined in the
section above, before accessing
the door latches. There are two (2)
door latch mechanisms on top the
glass door as shown in Figure 8.
Each latch has a hole at the front
to use the door tool, supplied with
the unit, to pull the mechanisms
straight out and up. When the
top latches are unhooked, lean
the door forward and then lift it
up out of the alignment slots at
the bottom corners of the firebox,
shown in Figure 18.
To replace the glass door, simply
reverse the above procedure.
Warning:
Do not touch or attempt
to remove the glass door if the
fireplace is not completely cold.
WARNING: Never operate the
fireplace with the glass door
removed.
g
Lass
D
ooR
R
emovaL
:
14
Face
The Face on the S20I/ S20ID needs to be
removed whenever access to the firebox
is required. To remove the face loosen tow
screws at the bottom of the face, then rotate
the door as shown in Figure 16. The face is
hooked on the frame at the top and will need
to be rotated past 45 degrees until is is free.
Lay the Face down on a towel or blanket to
prevent scratching the finish. To re-install
simply reverse the procedure.
Figure 16. Face Removal
