16
Maintenance And Service
Warning:
Failure to position the parts in accordance with this manual, or failure to use only parts
specifically approved with this appliance, may result in property damage or personal injury.
At least once a year, run through the following procedures to ensure the system is clean and working
properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not
blocked by anything. The pilot flame should be blue with little or no yellow on the tips.
The venting system must be periodically examined; it is recommended the examination is done by a
qualified person.
c
Leaning
t
he
p
ainteD
s
uRfaces
:
Painted surfaces should be periodically wiped with a damp cloth when the unit is cool.
Figure 19-A: Door Spring Latch Locations
The glass door of the fireplace is retained at the top
by two spring latches as shown in Figure 18. Release
the latches by placing the hooked end of the door
tool in the hole on the door latch mechanism (see
Figures 19-A,B) and pulling the latch forward then
out to the side. When the two (2) latches have been
released, tilt the top of the door forward and lift up
to remove the door (Figure 20). To re-install the
glass door simply reverse the procedure.
Warning:
Do not touch or attempt to remove the
glass if the fireplace is not completely cool.
Never operate the fireplace with the glass
removed.
CAUTION GLASS MAY SEPARATE FROM DOOR.
Figure 19-B: Door Latch Release.
Figure 20: Door Removal
g
Lass
D
ooR
R
emoVaL
:
Summary of Contents for EX32
Page 42: ...42 Notes...
