Enviro EG31 Nova, Owner'S Manual

Page: 10 / 36

R
epLacing the
g
Lass
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see p
arts
l
Ist
). Wear gloves when handling damaged glass door assembly
to prevent personal injury. When the glass door assembly is being transported, it must be wrapped in
newsprint and tape and/or a strong plastic bag. Do not operate with the glass front removed, cracked
or broken. Removal and replacement of the glass from the door must be done by a licensed or qualified
service person. The glass must be purchased from an ENVIRO dealer. No substitute materials
are allowed.
c
Leaning
t
he
p
ainteD
s
uRFaces
:
Painted surfaces should be periodically wiped with a damp cloth when the unit is cool.
b
uRneR anD
b
LoweR
R
emoVaL
:
1. Turn the unit off, remove the glass door (see m
aIntenance
a
nD
s
erVIce
- g
lass
D
oor
r
emoVal
) and the
log set. Caution: Bleed lines before lighting and light pilot with door open.
2. Remove the burner tray top by removing the two (2) T-20 screws located in the center of the burner
tray (see Figure 7). Slide tray to the left and lift out.
3. Remove brick panels (see s
econDary
I
nstallatIon
- b
rIck
p
anels
I
nstallatIon
).
4. Remove the surround panel by lifting it straight up and then out to free it from the body of the unit.
5. Turn the gas supply off and remove gas connection and disconnect the wiring from the side of the
appliance.
6. Remove the three (3) T-20 screws that hold the air deflector in place on the back firewall (see Figure
7) and undo the remaining screws that hold the burner assembly in the appliance. Carefully remove
the gas tray assembly from the firebox, ensuring that wires and gas lines are not damaged.
7. Remove the blower and housing from the gas tray assembly by removing the fastening screws located
on the back of the gas tray assembly. Disconnect the wiring from the fan temperature sensor and
remove.
To install; follow steps 1 through 7 in reverse. Perform a gas leak check on all gas line with a soap and
water solution or an approved method and check burner and blower assembly for proper operation.
Maintenance And Service
Gas and electrical
tray complete
Air deflector
Burner top
Figure 7: Removing Burner and Gas Tray.
10