30
31
s
uRRounD
p
aneL
s
cRew
i
nstaLLation
:
Trimmable Panel Install: The trimmable panel is installed by sliding slots in the bottom of the panel into
screws on the stove. Two screws must be installed at the bottom of the cabinet sides as shown.
instaLLation:
Using a T20 screwdriver,
screw one (1) #8-32 x .5” screws
approximately 1/4” into the bottom of each
Side Extension (see Figure 44).
Figure 44: Trimmable Panel Screw Install.
A
o
ptionaL
t
RimmabLe
p
aneLs
:
Modifying the Surround Panel:
The E33 Trimmable Surround Panels are large rectangular panels that may be cut for use in cases that a non-
standard fireplace opening (e.g. an arched opening) is to be filled. Optionally this surround can be left uncut
and placed in front of the fireplace opening.
1. Measure the fireplace opening and/or make a template of the fireplace opening.
2. Transfer the measurement to the Trimmable Surround.
3. If desired, offset the measurements by approximately
1
/
8
” (3mm) to the inside; this will allow for the panel
to be placed just inside the fireplace opening for a cleaner appearance.
4. Cut along the preferred line (from direct measurements of offset) and remove any sharp edges.
5. The panel can be touched up with a high temperature metallic black paint available from your dealer.
INSTALLATION:
1. Using the supplied hardware install a Trimmable Panel Bracket, on its short leg, onto each side of the stove
using a T-20 Torx screwdriver.
See Figure 45
for the screw location and bracket orientation.
2. Install the Trimmable Panel, WITH THE FLANGES FACING OUT, onto the Side Extensions and in front of
the Panel Brackets by hooking the Panel’s top flange onto the alignment pins on top of the Top Extension (See
Figure 45).
3. Using the remaining hardware attach the Trimmable Panel to the Panel Brackets using a T-20 Torx
screwdriver (See Figure 46).
Figure 45: Panel Bracket
Installed and Pin Location
Figure 46: Trimmable Panel Installed
Secondary Installation
