31
Single calibration
Each sensor is assigned an individual calibration table. Afterwards, a throughput calculation takes
place on the basis of the individual throughput values.
2.1
Calibration factor
Input:
0.01 … 9.99
Factor for the subsequent adjustment of the
actual measurement. All measurements are
scaled by this factor.
2.2
Calibration filter [s]
Input:
1 … 9999
Filter time for recording the raw value during
calibration. It would be made an average out
of the measured RAW-values.
2.3
Calibration points
Input:
2 … 5
Number of support points for
a linearisation above the operating range.
2.4
Calibration unit
Selection:
m, ft
Selection of the velocity unit.
2.5
Cross-sectional area [m
2
]
Input:
0 ... 92
Cross-sectional area of the pipe to be
monitored line, for calculation of air volume
(A x v =V).
