User Manual
Document PN: 50847
www.enttec.com
Covered by US patent 08950901
5
To record your own colours, please scroll to the desired
slot (from 01 to 64), feed the desired data through the
DMX port until you are happy with the look. Then press
the SET key to overwrite the preset.
IMPORTANT NOTES:
When the light is powered on, it will automatically take
preset 01 as the default power on value, if the Lamp On
Mode setting is ON. This feature is handy for the user to
set up the desired colour combination for the fitting to
start every time it is powered up.
Note that the strobe feature is not a supported preset.
Any incoming DMX data will override the presets, so
ensure that there is no DMX data coming in before
navigating this menu intending to playback the different
colours.
Running the Factory Defaults RDM command will restore
all the presets to the original values and user recorded
presets will not be recoverable.
Lamp On Mode Menu
This setting instructs the ET about what to do after a power
up sequence.
If DMX or OFF settings are chosen, the ET will stay off and
will wait for DMX instructions.
When Lamp On Mode = ON the ET will power up and then
output whatever drop has been recorded in slot 01 of the
presets. Please notice that any incoming DMX will override
this preset, as DMX takes the highest precedence.
PWM Frequency Menu
The PWM driving frequency can be adjusted. This might
have an impact on the way some cameras respond to the
light emitted by the A2 ET Mk2.
Backlight Menu
The NORMAL setting will turn the display green back light
on after any key operation. It will turn it off after a 15
seconds of in-activity. The ON setting will keep the back
light always on. The OFF setting will keep the back light
always off, regardless of any operation.
Factory Defaults Menu
Running the Factory default sequence will reset all the user
configurable parameters, including DMX address, presets,
Personality, Lamp On mode, Etc.
Temperature Menu
This menu shows the current fixture temperature in degrees
Celsius.
LED and CPU operating temperatures can be monitored
from the control panel as well as RDM.
Test Menu
Using this menu you can test every group of LEDS in the ET
fitting. The LEDs will turn on at full power, so avoid looking
at the light directly when performing the test.
Firmware Version
Indicates the current firmware version installed in the
fitting. Please check ENTTEC website for latest firmware
version.
Firmware Update
Updating the firmware of the ALEPH2 ET Mk2 requires an
ENTTEC USB Pro or a Pro Mk2 USB interface plugged in to a
PC USB port. Connect the USB PRO to the ET through a
standard 5 pin DMX cable.
