User Manual
Document PN: 50847
www.enttec.com
Covered by US patent 08950901
2
Cleaning
It is important to clean the ALEPH2 ET Mk2 to maintain a
long service life. Make sure the unit is unplugged before
you attempt any cleaning.
•
Surface dust should be removed with an air
compressor, please make sure you do not blow
compressed air directly inside the unit.
•
Optics can be cleaned with a glass cleaner or IPA
with a soft cloth
•
Make sure the unit is dry and there is no cleaning
fluid residue before powering the unit after
cleaning.
Safety
•
Do not expose the ALEPH2 ET Mk2 to rain or
moisture, doing this will void your warranty.
•
Do not spill water or other liquids into or onto
your unit.
•
Do not look directly into the LEDs, doing so may
damage your eyes.
•
Check that the local power outlet matches the
required voltage (120 → 240V AC)
•
Make all the connections before you plug in the
main power.
•
Do not remove the cover under any condition.
There are no user serviceable parts inside.
•
Never operate this unit when its cover is
removed.
•
Never plug this unit in to a dimmer rack.
•
Always be sure to mount this unit in an area that
will allow proper ventilation. Allow at least 20 cm
between this device and a wall.
•
Make sure ventilation holes are clean and
unobstructed.
•
Do not attempt to operate this unit, if it becomes
damaged.
•
Always mount this unit in a safe and stable
manner.
•
Power-supply cords should be routed carefully.
•
The unit should be situated away from heat
sources
Control Panel
After powering up, the current firmware version is
displayed, followed by the DMX Start Address.
The unit can be configured by using the 4 buttons under the
display as follows.
The following is the menu setting structure:
