Section 15
Appendix
93
Select the flash file
. This will be a file with a .hex extension supplied by ENTRON UK.
Select connect to the iPAK2
. NetFlash will connect to the target control and report the
current firmware status.
Select start transfer to the iPAK2
. Select a memory to re-program and NetFlash will
transfer the flash file to the iPAK2.
If required, select change the active memory
. NetFlash will mark the selected memory for
activation. When iPAK2 restarts, the selected memory becomes active.
Setting the IP address
iPAK2 uses a device server for Ethernet communications on COM0 and COM1. The device server is an xPort
AR, manufactured by Lantronix
www.lantronix.com
To set the IP address of the iPAK2 use Lantronix’s DeviceInstaller software
www.lantronix.com/products/deviceinstaller/
Download the documentation and Device Installer software. Install the software.
Follow the instructions in the documentation to search for all Lantronix devices on your network. Device
Installer will show the iPAK2 device server in the device list. The example shows an iPAK2/xPort AR
with a hardware address of 00-20-4A-D5-FB-7B:
