Section 14
Tutorials
91
07
Resetting faults
Fault conditions and error messages can be reset in several ways.
WSP3
LOW MAIN CURRENT
From the Status screen press
‐‐ 0 a prog 0
‐ ‐ 10.1 ka 5.80 kn
‐‐ 0 a ~30.5%
NetFlash
Use
to select the Metrics window then select the
reset button
Discrete input
Input
Pin number
Description
Reset fault
P2.15
This input resets the Fault output and clears the status
messages. Only momentary application is required
(minimum time 40ms).
The discrete I/O is described in Section 4
Discrete I/O
.
Bus input
Input
Channel
Address
Description
Reset fault
Bit 6
%QX0.6
This input resets the Fault output and clears the status
messages. Only momentary application is required
(minimum time 40ms).
The bus I/O is described in Section 5
MODBUS I/O
.
