© Entrematic
Group AB 2015
November 2016
6020031A — Commercial HVLS Fans
23
TROUBLESHOOTING,
continued
PROGRAMMING THE REMOTE
NOTE:
The fan ships from the factory with the remote pre-programmed
and ready to use. To program or reprogram the remote, access
to the controller box will be required. Ensure that the fan is
not running and there is power to the controller box.
1. Locate the controller box and ensure that there is access
to the top cover.
2. On the top cover, locate the remote program access hole.
See Fig 22.
3. With a small dowel or other blunt object,
gently
depress
the programming button for 10 seconds.
4. On the remote, press and hold the power off button for 6
seconds. Release the button when the green LED on the
remote begins to flash to show that the wireless remote
has been associated with the controller. See Fig 23.
CHANGING THE BATTERY IN THE REMOTE
Burn hazard. To avoid the risk of fire, explosion or burns, DO
NOT recharge, disassemble, crush, puncture or incinerate
the battery. DO NOT heat the battery above 212°F (100°C).
NOTE:
A dead battery must be replaced promptly in order to retain
programming.
1. Remove the wireless remote from the faceplate assembly.
2. Place a flathead screwdriver into the slot at the bottom of
the remote. Twist to open.
DO NOT
press buttons without
back enclosure on. See Fig. 24.
3. Slide the battery out, toward the top of the remote.
4. Slide a new CR 2032 battery underneath the contact strap,
with the (-) terminal toward the front of the remote.
5. Replace the back enclosure.
6. Ensure proper fan operation. If the remote fails to control
the fan, re-program the remote using the process described
above.
7. Re-install remote into faceplate as required.
Program
access hole
Controller box
Circuit breaker
Power off
Green LED
Fig. 22
Fig. 23
Fig. 24
