Entre Matic Ditec Energy 0DT828, Installation Manual, Page: 41 / 48

- 41 -
0DT828 2014-06-13
FuSES
ID Value Dimension Circuit
F1 - F2 12A - 500V 10.3 x 38 monophase line
ADJuSTMENT LIMIT SWITCH
1. Set the deceleration ramps to zero. (T5 - T6)
2. Calibrate the limit switch (C) on the gearmotor so the door stops approximately
200-300mm from the closure point.
3. Calibrate the opening limit switch (A) at the opening point.
4. Calibrate slowdown limit switch (B) in such a way that it engages at
approximately ¾ of the opening stroke.
5. Calibrate the opening speeds using trimmer (T3) and closure (T4).
6. Calibrate the opening (T5) and closure (T6) trimmers of the deceleration
ramps in such a way as to cause stopping in the actual door open and door
closed positions.
COMMAND TROuBLE VERIFY
Every command, in every
curtain position
The curtain and the motors
don’t move
• Control unit test was failed
(led 13 green OFF, led 14 red ON)
Opening Command The motor moves erratically
or does not reached the set
speed
• Check if the J2 jumper has been cut (brake is not activated)
• Check that the mains voltage is constant during the operation
• Lower the opening speed trimmer (T3)
During the closing
movement
The motors doesn’t made
deceleration ramp
• Adjustment of the closing limit switch (C) at 300 mm from
the floor
• Adjustment of the deceleration ramp by means the trimmer T6
NB for general diagnostics see also at page. 43
TROuBLESHOOTING
Always cut the jumper J2 on door Ditec Energy
47E
C
B
A
B
C
300
A
¾
J1
1
230 V 50/60 Hz
L N
GND
T2
T4
T6
T1
T3
T5
DL 10 11 9 8 7 6 5 4 3 2 1
12
15
16 17
13
14
41 40 20 9 8 4 3 2 1 1 0 LAMP 1 11 12 13
+F -F U V W
ON
OFF 1 2 3 4
U24
J2
ON
F2 F1
CNT
EN