PROBLEM: Cover does not fit on the lock.
▪
CHECK welding—If the lock chassis was welded to the mounting
surface; verify that there are no welds that extend beyond the
edge of the chassis back plate.
▪
CHECK wire routing to ensure that the placement of the wires is
not inhibiting the proper fit of the cover to the lock chassis.
▪
Cover must be straight on and slid into position (DO NOT TILT).
PROBLEM: Manual override does not work.
▪
CHECK cover to verify that the lock cover is fully seated and
securely fastened in place.
▪
CHECK mortise lock installation.
▪
VERIFY that the compatible cylinder lock is correctly installed
and functions properly—REVIEW installation instructions and
CHECK rotation direction.
▪
Check wire routing to ensure that the placement of the wires does
not impede the rotation of the cam or movement of the latching
mechanism.
▪
CHECK that the GL1 is being used in Fail Locked mode—manual
override does not work in Fail Safe mode.
wwww.EntraPASS.com / 8641 S. Warhawk Rd., Conifer, CO 80433 - Tel: 303-670-1099 - Email: [email protected]
wwww.EntraPASS.com / 8641 S. Warhawk Rd., Conifer, CO 80433 - Tel: 303-670-1099 - Email: [email protected]