3.
ROUTE all electrical wiring through either the provided wire conduit
coupling in the bottom of the lock chassis or through the ½” [12.7
mm] hole in the rear of the lock mounting chassis (see Figure 7,
“Wire Routing”).
4.
FEED wires through the hole in the side of the lock chassis opposite
to the cylinder lock, if installed.
5.
IF
there is no cylinder lock installed,
THEN
FEED wires through either side of the lock chassis (see
Figure 7).
Figure 7. Wire Routing
6.
CONNECT wires to the terminal block on the PC board (see
Figure 8, “PC Board Terminal Block,” and Figure 9, “System
Connections”).
wwww.EntraPASS.com / 8641 S. Warhawk Rd., Conifer, CO 80433 - Tel: 303-670-1099 - Email: [email protected]
wwww.EntraPASS.com / 8641 S. Warhawk Rd., Conifer, CO 80433 - Tel: 303-670-1099 - Email: [email protected]
