background image

8

6. Suction control

The suction control in the hose handle lets you

regulate the air-flow to prevent the nozzles from

fastening to the surfaces you are vacuum cleaning.

7. Start/Stop

a)Foot-operated on/off switch.

b)On the S 2 version a separate switch is provided

to change the motor speed .

c)Plug-in point for powered carpet nozzle. Power is

supplied to the socket when the machine is switched

on.

8. Warning!

Never attempt to vacuum liquid, glass fragments or

ashes!

Wet surfaces can expose the operator to possible

electrical shock.

9. Filter

The filters are located inside the lid. To reach them

lift out the filter holder (a). The standard filter(b) and

fine filter (c) should be inspected at regular

intervals,e.g. when you change dust bags, and

replace if necessary. Instead of these two filters you

can fit a micro filter of HEPA-quality (e), wich traps

99,99% of all particles larger than 0,3 microns. The

machine is also fitted with a backupp filter (d)

located above rhe motor. This filter should also be

inspected and replaced  if necessary.

NB!

Remove the plug from the socket before performing

service or maintenance.

1. To open

a) Pull the retaining clips upward and outward .

b) Lift the cover from the container.

2. Dust bag

Fit the opening on the dust bag over the air inlet.

Press the membrane over the flanged edge on the

inlet. Secure with the lock washer. Use only original

dust bags.

3. Hose connection

Push the hose coupling all the way in and turn

clockwise.

4. Wand assembly

a)Telescopic: 

Push  down the catch and then adjust

the length. Max.950mm,min.630mm.

b)Standard: 

Fit the sections together and twist to

lock in place.

 5. Tools

The accessories shown in the pictures may vary

from model to model.

a-b) Combination nozzle

Adjust the nozzle according to the requirements of

the floor you are cleaning. Work with the brush on

hard floors and without it on soft floors.

c) Universal nozzle

for both hard floors and carpets.

d) Crevice nozzle

Use to clean furniture, radiators and others hard-to-

reach places.

e)

 

Small combi-nozzle:

The small combi-nozzle combines a dusting brush

for furniture, picture frames, mouldings etc. with a

fold-out nozzle for cleaning curtains, furniture and

other soft surfaces. The clip on the hose handle

holds the nozzle when it is not in use.

Summary of Contents for GD 930









Reviews: