ensto Chago Media, Installation Instructions, Operation Instructions

Page: 36 / 49

RAK107
22.5.2018
36
correct direction. Remember to adjust the thermostat
value back to the default value +35°C degrees (K2).
10. Close the TFT LCD –element and front door.
How to change heat exhanger fan:
1. Open the front door and TFT LCD –element.
2. Power off the display from the main switch Q1.
3. Remove hatch cover and fan’s wiring.
4. Replace the fan and put the hatch back to plate so that
fan’s blow direction is as it were.
5. Re-connect fan’s wiring.
6. Power on the display with the main switch Q1.
7. Test the functionality of the fan by adjusting the
thermostat value below the ambient temperature.
Check that the fan starts to rotate and it blows to
correct direction. Remember to adjust the thermostat
value back to the default value +35°C degrees (K2).
8. Close the TFT LCD –element and front door.
9.6.3 Thermostats
Thermostat K1 controls the heating element. When the inside
temperature of the housing goes below +15°C degrees, the