BrightEye 91 HD Upconverter with AES Audio
BrightEye 91 - Page 16
Video Out
• Hor Timing
– use this control to adjust the horizontal timing of the output
signal to place the leading edge of sync coincident with other sources (range
is
-2000
to
2000 clocks
, default is
0 clocks
).
• Vert Timing
– sets the vertical timing to a typical setting of 0 lines (range
is
-1000
to
1000 lines
, default is
0 lines
).
• Test Pattern
– select
On
or
Off
.
On
enables the test pattern to be sent to
the video output.
Off
disables the test pattern from being sent to the video
output.
• HDMI Status
– reports the status of a monitor or a display connected to
the HDMI output (
No Display
,
DVI Display
,
Unknown HDMI,
HDMI Non-Compat, HDMI Native, HDMI Compatible)
. Status information
comes from the display itself. Some displays may not work with the
BrightEye 91, depending on the formats that the display supports. For best
results, use a display that is
HDMI Native
.
• Captions Out
– use this control to enable or disable closed captioning (if
present on the input source material).
On
enables closed captioning by con-
tinuously transmitting captions (including any null or empty caption
packets).
Off
disables closed captioning by stripping captions from the
source material. The BrightEye 91 translates between CEA-608 and
CEA-708 standards for closed captioning as needed. Note that closed
captions are not supported for
1080p
and
1080sF
outputs.
• Graticule
– use this control to display on-screen graticule lines. These
alignment markers facilitate film transfer, post production and quality
control measurements relating to picture location for both the 4:3 and 16:9
aspect ratios.
Safe Title
displays the safe title boxes.
SD Protect Only
displays only the SD Protect area without displaying the safe title boxes.
Off
disables graticules.
• Target
– use this control to select the monitor on which graticule lines are
displayed. Choices are
All Outputs, Main Only
(the unit’s output BNCs),
or
HDMI Only
.
• Hor Flip
– Horizontal Flip is a special Mirror Output Mode that is useful
for flipping the image left-to-right for use with on-screen talent or with
prism lens cameras. Select
On
to flip the output image left to right. Select
Off (after Reset)
to turn Mirror Output Mode off. Power down the module
and turn it back on for the
Off
selection to take effect.
• Color
– use this control to set the color of the graticule lines. Choices are:
White
,
Gray
,
Black
,
Red
,
Blue
and
Green
.
• Transparency
– use this control to adjust the transparency of the graticule
lines from
0
(completely transparent) to
100
(no transparency).
See Video Out diagram on next page
NOTE
:
