Enraf Nonius TensMed 911, User Manual

Page: 8 / 15

6
A burst frequency can be set for treating chronic pains, where the use of continuous stimulation with a low
pulse frequency would be too painful. A burst consists of an interrupted train of pulses. Each burst lasts
for 100 ms and the burst rate can separately be adjusted. See paragraph 10 for details. With this milder
TENS waveform it is easier to exceed the motorial threshold stimulus.
5 Package Contents
1427940 TensMed 911
5.1 Standard Accessories
The following accessories are included with your TensMed 911:
3444001 Electrode cable 2 mm, 2 pc in conformity with FDA CFR 898
3444057 EN-Trodes, self adhesive electrode 50x50 mm, 1 set 4 pc.
1427755 User manual TensMed 911
Alkaline AA 1,5 Volts (LR6) Batteries
Carry Pouch
5.2 Optional Accessories
3444056 EN-Trodes, self adhesive electrodes, size 32mm Ø, 1 pack = 10 sheets of 4 pc
3444135 EN-Trodes, self adhesive electrodes, size 50mm Ø, 1 pack = 10 sheets of 4 pc
3444143 EN-Trodes, self adhesive electrodes, size 70mm Ø, 1 pack = 10 sheets of 4 pc
3444057 EN-Trodes, self adhesive electrodes, size 50x50mm, 1 pack = 10 sheets of 4 pc
3444058 EN-Trodes, self adhesive electrodes, size 50x90mm, 1 pack = 10 sheets of 4 pc
3444146 EN-Trodes, self adhesive electrodes, double lead, size 50x100mm, 1 pack=10 sheets of 2pc
6 Installation
Insert Batteries:
Insert two batteries. (A diagram inside the battery compartment shows how to insert the batteries
correctly.)
To check if the batteries have been correctly fitted, press the ON/OFF button once and the LCD display
will start up and the LED Lights will come on. Press the ON/OFF button again to switch the unit off.
Use only AA Alkaline 1.5 volt batteries (LR6).
Do not mix old and new batteries.
The battery contains material that is noxious to environment. You should attend the local regulations
when disposing the battery.
Attach Leads:
Unravel leads and insert the plug(s) into either sockets in the end of the unit. If using only one lead use L1
(as marked on the unit next to the socket).
Attach Electrodes to leads:
Remove electrodes from the bag and connect to the leads.
Simply push the plug on the electrode pigtail into the socket on the lead.