SOLAR PANEL TOP POLE MOUNT
ASSEMBLY INSTRUCTIONS (cont.)
ASSEMBLY
Step 1.
Connecting Channel Rails (#1)
(Only for UNI-TP models: 04A)
A. Lay two channel rails (#1) end to end.
B. Using a connector, bolt the channel
rails (#2) together. Tighten the
5/16-18 x 3/4” hardware (hex bolt,
flat washer, lock washer, and hex nut)
to 144 in-lbs (dry).
C. Repeat with the remaining set of channel
rails.
Step 2.
Attach Channel Rails (#3) to
Module(s)
A. Lay the modules face down on a
protected surface in the suitable
orientation. Leave at least 1/4”
between panels.
B. Lay the channel rails (#3) on the back
of the modules with the evenly-spaced
holes down, so the flat side of the rails
are facing towards the outside edges
of the panels.
C. Secure the rails with 1/4-20 x 3/4”
hardware (hex bolt, flat washer,
lock washer, and hex nut) in each
of the PV mounting holes. Tighten
the bolts to 84 in-lbs (dry).
D. Repeat steps, attaching the remaining
PV modules to the remaining channel
rails.
Page 6
(#1)
(#2)
(#3)
