enphase ClipperCreek LCS, User Manual

Page: 24 / 36

LCS User Manual
Page 24
MOUNTING THE SAE J1772 CONNECTOR
HOLSTER
The SAE J1772 connector holster comes standard to provide a convenient,
protective housing for the SAE J1772 connector head when it is not in use.
•
The SAE J1772 connector holster should be placed so that users have easy
and safe access to the SAE J1772 connector.
•
For indoor installation, mount the SAE J1772 connector holster between 18
and 48 inches above the ground or grade.
•
For outdoor installation, mount the SAE J1772 connector holster between
24 and 48 inches above the ground or grade.
•
The SAE J1772 connector holster has two vertically aligned mounting holes
spaced 5.45” apart, one each on the enclosure top and bottom. Use a ruler or
template to mark hole locations on the mounting surface.
•
The vertical alignment of the LCS and SAE J1772 connector holster
mounting holes allows for the convenient mounting of both components
onto the same post or wall structure. For example, the holster may be
mounted directly above the LCS.
•
Place the SAE J1772 connector holster such that both mounting holes can
take advantage of solid structural framing inside of the wall or a strong wall
surface such as plywood.
•
A set of exterior wood screws and stainless steel washers are included for
the purposes of mounting the SAE J1772 connector holster to a wooden
surface.
•
For mounting to a solid surface such as concrete, brick, or stone, alternate
hardware may need to be procured. Examples of solid-wall mounting
hardware include multi-sets, wedge anchors and sleeve anchors. Use the
type of mounting hardware most appropriate for the supporting structure.
Figure 7: Mounting the LCS Connector Holster using the Exterior Wood
Screws and Washers