Enovate Medical Envoy, Manual

Page: 17 / 57

16
Initial Setup
ENVOY • MANUAL
STEP 5
Connect the monitor’s power cable
(pictured in red for demonstration
purposes only) and the video cable
(pictured in blue for demonstration
purposes only). Route each cable
from the monitor through the cable
management cover located on the
front of the monitor arm. Leave
enough slack above the cable
management cover to allow the
monitor to extend fully upward.
STEP 6
Continue routing each cable
behind the arm and through the
rear cable port at the base of the
monitor arm.
STEP 7
Follow Steps 1 - 6 for Montitor
and Computer Installation
STEP 8
Plug Monitor Power Cable
(pictured in red for demonstration
purposes only) into channel 2
monitor port and connect the
video cable (picutred in blue for
demonstration purposes only)
to the computer to your NUC/
Laptop or Thin Client.
STEP 9
Connect your NUC/Laptop
or Thin Client CPU Power
cable (pictured in green for
demonstration purposes only)
to channel 1 computer port.
Replace rear cable cover,
replace and lock desk surface.