Enoitalia DELTA 1, User Instructions, Installation And Technical Manual

Page: 9 / 14

8. ELECTRICAL WIRING
Before connecting the plug of the motor to the mains, check that the voltage of the motor corresponds with
that of the mains.
The electrical safety of the machine is only ensured if it is connected to an efficient earthing
system, wired according to current electrical legislation.
Inspection and any installation of appropriate electrical components must be performed by qualified
personnel.
The use of multiple sockets or adaptors is not recommended; should use of the same be indispensable use only
products corresponding to current safety legislation, observing the capacity limit in terms of current and
maximum power. Use a cable of 1.5mm section for extension leads of up to 20 m, and 2.5 mm for longer
leads.
9. STARTING UP AND STOPPING
Before starting up the user should make sure that there are no impediments obstructing
movement of the mechanical parts and, above all, make sure that nobody is in the vicinity of
the parts about to move; specifically that nobody has their hands, arms or other parts of the
body near the stalk outlet or inside the box.
Check, in addition, that the voltage of the motor corresponds with the mains.
Check that all the safety guards are correctly installed on the machine.
Check that the emergency stop button works properly.
After installing the safety box, in the case of three-phase 380V powered machines,, start the machine
and check through the hopper, if the direction of rotation of the shaft is clockwise. Otherwise, stop the
machine, unplug it from the main, and invert two phases of the electrical connection from the cable side
of the connection to the main
Install a collection tank for the stones below the rear protection, in order to avoid that these are thrown away
from the machine.
Then install a collection tank for the fruit pulp under the outlet fitting, or connect a pump suction from the
fitting.
If this preliminary inspection should reveal problems or prove negative, stop the machine, disconnect the plug
from the mains, notify the department chief, the supplier company, if applicable or Enoitalia s.r.l.
Should this preliminary inspection be successful, proceed as follows:

press the button on the control panel of the electric motor and the machine will start.

load the ripe fruit .

the machine will begin to destone the fruit. The stone will fall into the collection recipient, and the
pulp will exit from the connection fitting .

to stop the machine, press the red emergency button.

to start the machine, release the emergency button and start up the machine again
Should work need to be done on the inside of the machine body (obstructions or foreign bodies) proceed as
follows:
1.
turn off the machine and disconnect the power supply cable
2. use a tool to remove the foreign body and, if necessary, open the machine
3. close any parts opened and repeat the steps described for start-up.