ENKHO 154696.01, Original Instructions Manual

Page: 23 / 53

EN
23
excess current flow, electrolyte leakage,
heating of cells or batteries, bursting and
fire.
o) Keep battery away from a fire or heat. The
insulation materials will melt and the gas
release vent and protection system will
be damaged, causing electrolyte leakage,
bursting and possibly fire.
p) Do not allow the battery to contact with
water or gets wet, it may short-circuit,
overheat, rust or lose its functions.
q) Do not expose the battery to mechanical
shock, for example, by dropping, throwing
or crushing, causing electrolyte leakage,
cell and battery heating, bursting and fire.
r) Avoid the battery to directly connect
to electric source such as a car lighter
socket, or car battery, which may cause
excess current to flow at high voltage and
can cause electrolyte leakage, overheating
of a cell or battery, bursting and fire.
Safety instructions for
charger
● This charger can be used by
children aged from 8 years
and above and persons with
reduced physical, sensory
or mental capabilities or
lack of experience and
knowledge if they have
been given supervision
or instruction concerning
use of the charger in the
safe way and understand
the hazards involved.
Children shall not play with
the charger. Cleaning and
user maintenance of the
charger shall not be made
by children without adult
supervision.
● If the supply cord is
damaged, it must
be replaced by the
manufacturer, its service
agent or similarly qualified
persons in order to avoid a
hazard.
● Only use this charger
151220.01 to charge the
battery pack 151218.01.
●
To charge the battery, use
only the charger supplied.
● Never charge non-
rechargeable batteries.
●
During charging the
batteries must be placed in
a well-ventilated area.
Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low noise operating modes as
well as wear personal protective equipment.
Take the following points into account to
minimize the vibration and noise exposure
risks:
● Only use the product as intended by its
design and these instructions.
● Ensure that the product is in good condition
and well maintained.
●
Use correct attachments for the product
and ensure they are in good condition.
● Keep tight grip on the handles surface.
● Plan your work schedule to spread any high
vibration tool use across a longer period of
time.
Residual Risk
Even if properly operating and handling this
product in accordance with all the safety
requirements, potential risks of injury and