EN
22
is damaged or modified.
Damaged
or modified batteries may exhibit
unpredictable behavior resulting in fire,
explosion or risk of injury.
f)
Do not expose a battery pack or tool to fire
or excessive temperature.
Exposure to fire
or temperature above 130°C may cause
explosion.
g)
Follow all charging instructions and do not
charge the battery pack or tool outside
the temperature range specified in the
instructions.
Charging improperly or at
temperatures outsides the specified range
may damage the battery and increase the
risk of fire.
Service
a)
Have your power tool serviced by a
qualified repair person using only identical
replacement parts.
This will ensure that
the safety of the power tool is maintained.
b)
Never service damaged battery pack.
Service of battery packs should only
be performed by the manufacturer or
authorized service providers.
Specific safety warnings for the polisher
●
Wear ear protectors. Exposure to noise can
cause hearing loss.
●
Hold the power tool by two handles.
●
Wear a dust mask.
●
Ensure that the bonnet is well secured to
the buffing plate.
●
Wait until the polishing disc is flat on the
surface to be polished, then switch on the
polisher
●
Do not use any abrasives, which can destroy
the paint finish.
Special safety instructions for battery-
operated tools
a) Ensure that the tool is switched off before
inserting the battery.
Inserting a battery
into a tool that is switched on may result in
accidents.
b) Recharge the batteries indoors only
because the battery charger is designed
for indoor use only.
Risk of electric shock.
c) To reduce the electric shock hazard,
unplug the battery charger from the mains
before cleaning the charger.
d) Do not subject the battery to strong
sunlight over long periods and do not leave
it on a heater.
Heat damages the battery
and this is risk of explosion.
e) Allow a hot battery to cool before charging.
f) Do not open up the battery and avoid
mechanical damage to the battery. Risk
of short circuit and fumes may be emitted
that irritate the respiratory tract.
Ensure
fresh air and seek medical assistance in the
event of discomfort.
g) Do not use non-rechargeable battery.
This
could damage the appliance.
h) The recommended ambient temperature
range for the charging system during
charging is from 4ºC to 40 ºC.
i) The recommended ambient temperature
range for tool and battery storage is from
0ºC to 50 ºC.
j) The recommended ambient temperature
range for tool and battery use is from -5ºC
to 50 ºC.
k) Remove the battery from the device before
storage.
l) Electrolyte leaking from the cells can
cause damage to the skin, clothes or
any other items exposed to it. If the
electrolyte contacts the skin or clothes,
wash thoroughly with clean water. If the
electrolyte enters into the eyes, do not
rub the eyes but flush them immediately
with copious amounts of clean water such
as tap water, and immediately consult a
doctor.
m) Do not disassemble or modify the battery,
which can cause short-circuiting between
cells or between the cell and its wiring, and
disables the battery’s safety protection
system. These can lead to electrolyte
leakage, overheating or a cell or battery,
bursting and fire.
n) Avoid casual or inadvertent shorting of
a battery with metallic objects such as:
wire, tools, neckless or hairpins, which
can cause short-circuiting, which cause
Summary of Contents for 154696.01
Page 2: ...A B 1 1 2 3 3 4 6 12 11 10 9 8 5 7...
Page 53: ...cod articolo 154696 01...
