Engler Son-Mate II, Instruction Manual

Page: 24 / 31

Option “A”
Take the other end of the 1/4” water tubing that comes from the saddle valve and connect it to the
female quick disconnect. This is done by placing the hose coupling nut over the water tubing and
placing the hose into the back of the female quick disconnect, then tightening the coupling nut.
A-44303 Saddle valve assembly w/female connector & tubing
Option “B”
If you wish, the female quick disconnect may be mounted directly through the sink top or vanity
counter. If you choose this way, you must first drill a 1/2” diameter hole through the surface in the
space desired. (see next page) Then mount the female quick disconnect and tighten the mounting
nut to securely hold it in place. Then proceed to place the hose coupling nut over the 1/4” water
tubing. Place this tubing into the back of the female quick disconnect and tighten the hose coupling
nut securely.
1. To Pierce Existing Water Tube: You are now ready to pierce the copper tube. Turn the handle
of the saddle valve in a CLOCKWISE direction until it will go no further. The Saddle valve is now
installed and in the OFF position. Turn the handle of the Saddle valve counter-clockwise until
resistance is felt. Water is ready to flow into the dental unit. Check for leaks.
2. To Connect the Scaler to the Quick Disconnect: Push the male quick disconnect from the scaler
into the female quick disconnect until they lock and installation is complete.
Engler Engineering Corporation will not be held liable for any damage including, but not limited to
leakage caused by improper installation of our products.
Page 24 of 31