WATER FILTER CLEANING INSTRUCTIONS
SHOULD BE DONE AT LEAST QUARTERLY
1. Turn off water supply to unit or disconnect the male from the female water connector
2. Unscrew filter by firmly holding Point “A” in your left hand and Point “B” in your right hand.
(Refer to Figure) Next, unscrew by simultaneously rotating your left hand away from you and
rotating your right hand toward you. Continue this process until the filter unscrews into two
separate pieces.
3. The filter body consists of two sides, one with an outer male thread and another with an inner
female thread. Take the side with the inner female thread and look into it, should see an O-RING
and under it a FILTER DISC (Refer to Figure below).
4. Remove the O-RING by carefully prying it out of the inner wall with a fingernail or other dull object.
NOTE: Be careful not to rip or break this O-RING, a water leak could result.
1. Next, remove the FILTER DISC by turning the female side over and tapping it gently into the
palm of your hand.
2. Replace with new disc part # A-52031 and “O” ring part # A-52032.
3. Reassemble the filter in the reverse order as you disassembled it.
4. Turn on the main water supply and check for leaks.
Point A
Point B
Page 21 of 31
Summary of Contents for Son-Mate II
Page 1: ...VER A 09 24 2009 Page 1 of 31 ...
Page 14: ...Page 14 of 31 ...
Page 23: ...Page 23 of 31 ...
