ENFORCER
®
High-Speed Latching Continuity Tester
4
SECO-LARM
®
U.S.A., Inc
Installing Optional Belt Clip:
Troubleshooting:
Continuity test yields false positive
Press reset button.
Check Circuit Type is correctly set.
Continuity test yields false negative
Change the internal battery.
(Be sure to store tester in OFF mode.)
Internal battery depletes quickly
Be sure to store tester in OFF mode.
Also Available from SECO-LARM:
12/24VDC Auto-Sensing Tester
ST-BT03Q
DC Plug to Terminal Block
CA-161T
Illuminated Power Connectors
CA-1610-3FLQ / CA-1510-3FLQ
WARRANTY
This SECO-LARM product is warranted against defects in material and workmanship while
used in normal service for a period of one (1) year from the date of sale to the original consumer customer.
SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned,
transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to acts of
God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or
faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating
properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or
consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication.
However, the SECO-LARM policy is one of continual development and improvement. For this reason,
SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not
responsible for misprints or typographical errors.
Copyright © 2011 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or
copied, in whole or in part, without the written permission of SECO-LARM.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
E-mail: [email protected]
1.
Open the
case and
remove the
circuit board.
2.
Drill two
1
/
4
”
holes at the
guide points
as shown.
Order Part# 763-166%
MiST-BL01Q_1111.docx
PITSW1
Guide Points
3.
Using the
included
screws,
attach the
belt clip.
4.
Reclose the
case.
Belt Clip
Front View
Back View
Side View
Inside View
