ENFORCER Wireless Video Door Phone
6
SECO-LARM U.S.A., Inc.
1.
Position the camera so the area to be monitored is easily visible,
optimally 5ft (1.5m) above the ground. Do not position the
camera in direct sunlight, or where it will be exposed directly to
rain or snow.
NOTE: For best results, the visitor should stand 2.5~5ft
(0.8~1.5m) away from camera.
2.
Cut a hole large enough to run the min. 21AWG 2-conductor
wire to the door unlock device through the wall, as well as to the
included power supply.
3.
Install the camera bracket to the wall with three screws. Use
screw anchors if the bracket is mounted on drywall or brick.
4.
Run the 2-conductor wire from the camera through the wire hole
in the bracket to the optional door unlock device.
5.
Install the rechargeable lithium ion battery into the camera. The
battery will act as a backup power source in case of a power
outage.
6.
Connect the AC adapter (see Camera Wiring Diagram on pg. 5).
7.
Mount the camera into the bracket:
o
Push the top of the camera into the top of the bracket.
o
Push the bottom of the camera into the bottom of the
bracket.
o
Screw in the bottom of the camera to fix the camera into
the bracket and push the plastic screw cover into the
bottom of the bracket, over the screw.
NOTE: Do not block the PIR sensor on the camera.
5ft
(1.5m)
3
3
/
4
”
(96mm)
2
2
/
16
” (54mm)
Install the monitor battery:
Remove the battery cover on the back of the monitor and insert the included
BP-6M lithium ion battery.
BP-6M
Installation – Monitor:
Installation – Camera:
