ENFORCER Wireless Video Door Phone
SECO-LARM U.S.A., Inc.
11
To reset the camera and pair a first monitor:
1.
Clear the camera’s existing pairings:
a.
Remove the camera from the bracket.
b.
The alarm will begin to sound.
c.
Remove the battery from the camera then replace the battery to deactivate the tamper
alarm.
d.
Use a paper clip or other small object to press and hold the camera’s reset button for
three seconds. A beep confirms the pairings have been cleared.
2.
Pair the monitor to the camera:
a.
Turn on the monitor by holding the “ON/OFF” button for three seconds.
b.
Quickly press the “ON/OFF” button three times. The screen will display “Pairing” for
about 15 seconds. The monitor will allow pairing only once per bootup, so you may
need to power it OFF and ON again if the attempt fails.
3.
Pair the camera to the monitor:
a.
While the monitor displays “Pairing”, press the camera’s reset button twice.
4.
One beep confirms the pairing of the first monitor. Return the camera to the bracket:
a.
Mount the camera in the bracket.
b.
Press the doorbell button on the camera to test the connection.
The camera’s tamper alarm will sound when the camera is removed from its bracket, warning the
homeowner of possible vandalism. Only the first programmed monitor will sound an alarm.
NOTE: If the camera is removed and replaced within 2 seconds, the camera will instead send a
warning call to the monitor. Answer the call as normal by pressing the “Talk” button, and
then again to hang up the call.
1.
To disable the tamper alarm if no monitors are paired with the camera:
a.
Return the camera to the bracket.
b.
If the alarm persists, unplug the camera and remove the battery.
c.
Return the camera’s battery and reconnect it to power.
2.
To disable the tamper alarm if one or more monitors are paired with the camera:
a.
Repeatedly press the “Talk” button on one of the paired monitors to disable the
tamper alarm.
b.
If the alarm persists, unplug the camera and remove the battery.
c.
Unplug each monitor and remove each monitor’s battery.
d.
Return the camera’s battery and reconnect it to power.
e.
Insert each monitor’s battery and reconnect each monitor to power.
Tamper Alarm:
Resetting the Camera and Pairing a First Monitor:
