1164-EnertexKNXIPSecureRouter_US-2.odt, 2019-03-25
Seite 15 von 19
Telnet
Telnet can be used to request additional information from the IP router. Telnet access is factory-
protected with the password "knxsecure".
Once the router is in secure mode, the telnet interface is disabled.
Although it can be enabled for developer purposes prior to programming the secure mode, this is
a security risk.
help
Displays all available commands
ifconfig
Displays network parameters
IP mode.......: DHCP
IP............: 192.168.33.142
Subnet mask...: 255.255.0.0
Gateway.......: 192.168.33.1
NTP server....: 192.53.103.108
Sys multicast.: 224.0.23.12
RT multicast..: 224.0.23.12
Hardware addr.: 00:50:c2:79:3f:ff
Sys multicast: Multicast address for System telegrams
RT multicast: Multicast address für routingt telegrams
ifconfig [help|dhcp|ip
|mask]
Set network parameters via the telnet interface.
Expamples
Setting IP Addresse with DHCP:
ifconfig dhcp
Statically set the IP address to 192.168.1.2 (in this case, the gateway and mask should also be
adapted, see below)
ifconfig ip 192.168.1.2
Set the gateway to 192.168.1.1:
ifconfig gw 192.168.1.1
Set the mask to 255.255.255.0:
ifconfig mask 255.255.255.0
tpconfig
Show KNX parameters
KNX bus state.: up
KNX address...: 15.15.000
Serial number.: 00a600000001
tpconfig [help|set]
Set KNX parameters via the telnet interface.
Set the TP address to 1.1.0:
tpconfig set 1.1.0
lcconfig
Coupler type..: line coupler
IP > KNX:
GA 013......: route
GA 1415......: filter
GA 1631......: block
Ph. addr......: filter
Broadcast.....: route
KNX > IP:
GA 013......: route
GA 1416......: filter
GA 1631......: block
Ind.addr......: filter
Broadcast.....: route
Check IA rout.: disabled
Ind.Addr.tlg..: individually addressed telegrams are 3 times
repeated
systembc [0|1]
Set certain bits in the system broadcasts so that IP routing is possible even on older devices
(e.g. Gira Homerserver). By default, this compatibility mode is turned on.
Wrong handling of bits in system broadcasts (necessary for e.g. Gira
Homeserver) is 1 (on)
progmode [0|1]
Query or change programming mode (0 = off, 1 = on)
apdu [55..248]
Read or configure the maximum length of the KNX TP telegrams. This may be necessary if
there is an incorrect implementation of a TP stack. In that case the ETS may try to use
telegrams with 248 bytes payload, but the TP device can not process (e.g. Zennio Z35i).
Default is 248 and should only be changed if necessary.
# apdu
maximal len of a KNX telegram 248.
Usage: apdu [55 .. 248]
Enertex
®
Bayern GmbH – Ebermannstädter Straße 8 - 91301 Forchheim - Deutschland - [email protected]
